LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 391 (Engine System -- General Information - Ranger) >> General Procedures >> Crankshaft - Connecting Rod Journal Taper, Out Of Round

Crankshaft - Connecting Rod Journal Taper, Out Of Round

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the crankshaft connecting rod journal diameters in two directions perpendicular to one another at each end of the connecting rod journal. The difference in the measurements from one end to the other is the taper. Verify measurement is within the wear limit.
    • Refer to appropriate ENGINE article for the procedure.
    • If out of specification, install new components as necessary. Refer to appropriate ENGINE article for the procedure.
    Fig 1: Measuring Crankshaft Connecting Rod Journal Diameters
    G03435296Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals