LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 376 (Engine Cooling) >> Removal And Installation >> Water Pump - 4.6L, 5.4L and 6.8L >> Removal

Water Pump - 4.6L, 5.4L and 6.8L: Removal

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING  .
  2. Remove the fan and fan clutch. For additional information, refer to COOLING FAN  .
  3. Remove the accessory drive belt.
  4. Remove the water pump pulley.
    1. Remove the bolts.
    2. Remove the water pump pulley.
      Fig 1: Removing Water Pump Pulley
      G03404871Courtesy of FORD MOTOR CO.
  5. Remove the bolts.
    Fig 2: Water Pump Removing Bolts
    G03404872Courtesy of FORD MOTOR CO.
  6. Remove the water pump from the cylinder block.
    Fig 3: Removing Water Pump From Cylinder Block
    G03404873Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals