LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 375 (Engine System - General Information) >> General Procedures >> Camshaft - End Play, OHC Engines

Camshaft - End Play, OHC Engines

WARNING: This page is about a different car, the 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Special Tool(s)
G03404773Courtesy of FORD MOTOR CO.
  1. Remove the roller followers. Refer to the appropriate ENGINE article for the procedure.
  2. Use a Dial Indicator with Bracketry to measure camshaft end play.
  3. Position the camshaft to the rear of the cylinder head.
  4. Zero the indicator.
  5. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
    • If camshaft end play exceeds specifications, install new camshaft and recheck end play. Refer to the appropriate ENGINE article for the procedure.
    • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head. Refer to the appropriate ENGINE article for the procedure.
      Fig 2: Recording Camshaft End Play (OHC Engine)
      G03404774Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals