LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 361 (Charging System (Battery, Mounting And Cables)) >> Removal And Installation >> Battery Tray >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery. For additional information, refer to BATTERY  .
  2. Remove the battery tray.
    1. Remove the four bolts.
    2. Disconnect the pin-type wire clips at the front and the side of the battery tray.
    3. Remove the battery tray.
    Fig 1: Removing Battery Tray
    G03430770Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals