LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Supplemental Inflatable Restraint System Deactivation Procedures) >> Ford Motor Co. >> Disabling & Activating Air Bag System >> Activating System (Excursion & F250/350 Super Duty)

Activating System (Excursion & F250/350 Super Duty)

WARNING: This page does not describe the selected car, but rather 102 other vehicles, including the 2002 Saturn Vue, 2002 Saturn SL2, 2002 Saturn SL1, 2002 Saturn SL, and 2002 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Wait at least one minute for backup power supply to deplete stored energy. Remove air bag simulator from clockspring connector. Install driver air bag module. See DRIVER AIR BAG MODULE . Remove air bag simulator from passenger air bag vehicle harness connector. Reconnect passenger air bag module connector.
  2. On all models except F250/F350 Super Duty SuperCab, remove simulator from passenger side safety belt retractor pretensioner electrical connector. Connect passenger side safety belt retractor pretensioner. Install lower trim panel. Repeat procedure for driver side.
  3. On F250/F350 Super Duty SuperCab models with safety belt retractor pretensioners, remove bolt and separate passenger safety belt retractor pretensioner from floor. Remove simulator from passenger safety belt retractor pretensioner connector. Connect passenger safety belt retractor pretensioner. Install passenger side safety belt retractor pretensioner and tighten bolt to 30 ft. lbs. (40 N.m). Install passenger side scuff plate. Repeat procedure for driver side.
  4. On F250/F350 Super Duty SuperCab models with safety belt buckle pretensioners, remove simulator from passenger side safety belt buckle pretensioner connector. Connect passenger side safety belt buckle pretensioner connector. Repeat procedure for driver side.
  5. On all models, reconnect negative battery cable. Recheck system operation. Perform SYSTEM OPERATION CHECK . Reprogram preset radio frequencies and set clock.
scientia non olet · About LEMON Manuals