LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 358 (Engine - 2.0L ZETEC) >> In-Vehicle Repair >> Oil Pressure Sender >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
    2. NOTE: The halfshaft is removed for clarity.
    Fig 1: Disconnecting Oil Pressure Sender Electrical Connector
    G03430315Courtesy of FORD MOTOR CO.
  2. Disconnect the oil pressure sender electrical connector.
  3. Remove the oil pressure sender.
    Fig 2: Removing Oil Pressure Sender
    G03430316Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals