Removal and Installation

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Drain the engine coolant. For additional information refer to ENGINE COOLING .
Remove the oil pan drain bolt and drain the engine oil.

Fig 1: Removing Oil Pan Drain Bolt
Courtesy of FORD MOTOR CO.
Remove and discard the oil filter.

Fig 2: Removing & Discard Oil Filter
Courtesy of FORD MOTOR CO.
Disconnect the coolant hoses at the cooler.

Fig 3: Disconnecting Coolant Hoses At Cooler
Courtesy of FORD MOTOR CO.
Remove and discard the oil cooler.

Fig 4: Removing & Oil Cooler
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Install a new oil cooler.
- Fill the crankcase with clean engine oil.