LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Exhaust Manifold LH >> Removal

Exhaust Manifold LH: Removal

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH heated oxygen sensor (HO2S) and the LH catalyst monitor. For additional information, refer to REMOVAL, OVERHAUL & INSTALLATION .
  2. Remove the bolts and the splash shield.
    Fig 1: Removing Bolts & Splash Shield
    G03429755Courtesy of FORD MOTOR CO.
  3. Remove the nuts and position the exhaust crossover aside.
    Fig 2: Removing Nuts & Position Exhaust Crossover Aside
    G03429756Courtesy of FORD MOTOR CO.
  4. Rotate the accessory drive belt tensioner clockwise, and remove the belt.
    Fig 3: Rotating Accessory Drive Belt Tensioner Clockwise
    G03429757Courtesy of FORD MOTOR CO.
  5. Remove the A/C compressor bolts and position aside.
    Fig 4: Removing A/C Compressor Bolts & Position Aside
    G03429758Courtesy of FORD MOTOR CO.
  6. Remove the nuts and LH exhaust manifold and discard the gasket.
    Fig 5: Removing Nuts & LH Exhaust Manifold & Discard Gasket
    G03429759Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals