Removal and Installation

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the hose from the power steering fluid reservoir.

Fig 1: Disconnecting Hose From Power Steering Fluid Reservoir
Courtesy of FORD MOTOR CO.
Disconnect the power steering cooler hose.

Fig 2: Disconnecting Power Steering Cooler Hose
Courtesy of FORD MOTOR CO.
Remove the front bumper cover.
Remove the nuts and the power steering fluid cooler.

Fig 3: Removing Nuts And Power Steering Fluid Cooler
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Fill, bleed and leak check the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION .