LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 349 (Automatic Transaxle/Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Torque Converter Operation Concerns: No Apply

Torque Converter Operation Concerns: No Apply

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE CONVERTER OPERATION CONCERNS: NO APPLY SPECIFICATION

Possible Component Reference/Action
233 - ELECTRICAL ROUTINE 
Powertrain Control System 
  • Electrical inputs/outputs, vehicle wiring harnesses, transaxle control module (TCM), TCC solenoid, internal wiring harness, TP, TFT, OSS sensor, RPM input.
  • Perform Torque Converter Clutch Operation Test; refer to DIAGNOSTICS  .
  • Run on-board diagnostic. Refer to SELF-DIAGNOSTICS for diagnosis.
333 - HYDRAULIC/MECHANICAL ROUTINE 
Improper Pressures 
  • Low line pressure
Main Control Valve Body 
  • Bolts out of torque specification
  • Tighten bolts to specification.
  • Gaskets-damaged, off location
  • Inspect gaskets. Install new components as necessary.
  • TCC solenoid not functioning properly
  • Check operation. Install new components as necessary.
Turbine Shaft 
  • Seals-damaged, missing
  • Inspect for damage. Install new components as necessary.
  • Holes-missing, plugged
  • Inspect for damage. Install new components as necessary.
Converter 
  • Converter
  • Inspect as described. Install new components as necessary.