LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 349 (Automatic Transaxle/Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Shift Concerns: Timing - Erratic/Hunting

Shift Concerns: Timing - Erratic/Hunting

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
SHIFT CONCERNS: TIMING - ERRATIC/HUNTING SPECIFICATION

Possible Component Reference/Action
210 - ELECTRICAL ROUTINE 
Powertrain Control System 
  • Electrical inputs/outputs, vehicle wiring harnesses, transaxle control module (TCM), shift solenoids, TPS, OSS, TFT sensors, EPC solenoid, internal wire harness.
  • Perform Shift Point Road Test and Torque Converter Clutch Operation Test; refer to DIAGNOSTICS  .
  • Run on-board diagnostic. Refer to SELF-DIAGNOSTICS for diagnosis.
310 - HYDRAULIC/MECHANICAL ROUTINE 
Fluid 
  • Improper level
  • Adjust fluid to proper level.
  • Condition
  • Inspect. Install new components as necessary.
Shift linkage (internal/external) 
  • Damaged, out of adjustment
  • Inspect. Repair as required. Verify linkage adjustment; refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .
Main Control Valve Body 
  • Bolts out of torque specification
  • Tighten bolts to specification.
  • Gaskets and separator plate-damaged, off location
  • Inspect for damage. Install new components as necessary.
  • Valves, accumulators, seals, clips, check ball-stuck, damaged, contaminated
  • Inspect for damage. Install new components as necessary.
Planetary Gear Sets 
  • Damaged
  • Inspect for damage. Install new components as necessary.