LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Engine Controls - Removal, Overhaul & Installation - BLACKWOOD, Expedition, F150 Pickup & Navigator - Gasoline) >> Computerized Engine Controls >> Powertrain Control Module >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Lincoln Navigator, 2002 Lincoln Blackwood, 2002 Ford Pickup, and 2002 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery ground cable. Remove the right front door scuff plate. Remove the right kick panel trim. Remove the harness connector bolt from engine side of cowl. Unplug harness connector from PCM. Remove retainer clip and PCM from passenger side of cowl. To install, reverse removal procedure. Tighten bracket bolts and connector bolt to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals