Suction Accumulator/Drier - Standard A/C: Removal

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Installation of a new suction accumulator/drier is not required when repairing the air conditioning system except when there is physical evidence of system contamination from failed A/C compressor or damage to the suction accumulator/drier.

Recover the refrigerant. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .
Remove the battery (10655). For additional information, refer to BATTERY, MOUNTING AND CABLES .
Remove the battery tray.
1. Remove the screws.
2. Remove the battery tray.
  
  Fig 1: Removing Battery Tray
  Courtesy of FORD MOTOR CO.

CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.

Fig 2: Disconnecting Evaporator Discharge Line

Courtesy of FORD MOTOR CO.

Disconnect the evaporator discharge line.

CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.

Disconnect the compressor suction line.
1. Remove the screw.
2. Disconnect the compressor suction line.
  
  Fig 3: Disconnecting Compressor Suction Line
  Courtesy of FORD MOTOR CO.
Disconnect the A/C cycling switch electrical connector.

Fig 4: Disconnecting A/C Cycling Switch Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the suction accumulator/drier (19C836).
1. Remove the screws.
2. Remove the suction accumulator/drier.
  
  Fig 5: Removing Suction Accumulator/Drier
  Courtesy of FORD MOTOR CO.
Remove the A/C cycling switch (19E561).

Fig 6: Removing A/C Cycling Switch
Courtesy of FORD MOTOR CO.