Line - A/C Refrigeration, Auxiliary: Removal

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove the condenser to evaporator tube (19835). For additional information, refer to LINE - CONDENSER TO EVAPORATOR, AUXILIARY A/C-HEATER SYSTEM .
Disconnect the suction accumulator/drier spring lock coupling. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .

Fig 1: Disconnecting Suction Accumulator/Drier Spring Lock Coupling
Courtesy of FORD MOTOR CO.

CAUTION: Use a wrench on each side of the fitting to prevent damage to the A/C fitting.

Fig 2: Disconnecting Compressor Suction Line

Courtesy of FORD MOTOR CO.

Disconnect the compressor suction line.
Remove the four clamps.
1. Remove the screw.
2. Remove the clamp.
  
  Fig 3: Removing Four Clamps
  Courtesy of FORD MOTOR CO.
Raise the vehicle.
Disconnect the underbody tube spring lock coupling. For additional information, refer to CLIMATE CONTROL SYSTEM-GENERAL INFORMATION .

Fig 4: Disconnecting Underbody Tube Spring Lock Coupling
Courtesy of FORD MOTOR CO.
Lower the vehicle.
Remove the auxiliary A/C refrigeration line.