LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 329 (Fuel Tank & Lines-Gasoline & Diesel) >> Removal And Installation >> Pump - Gasoline Engine >> Removal

Pump - Gasoline Engine: Removal

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related component. Highly flammable mixtures are always present and may be ignited, resulting in possible personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.
  1. Disconnect the battery ground cable (14301).
  2. Remove the fuel tank (9002).
  3. Place the fuel tank on a suitable work surface.
  4. Remove the fuel pump (9350) and sender.
    1. Remove the screws.
    2. Remove the fuel pump and sender.
    Fig 1: Removing Fuel Pump And Sender
    G01540186Courtesy of FORD MOTOR CO.