Torque Converter Operation Test

This test verifies that the torque converter clutch control system and the torque converter are operating correctly.

1. Carry out Quick Test with scan tool. Refer to the SELF-DIAGNOSTICS - CNG, FLEX-FUEL & GASOLINE article. Check for DTCs.
2. Connect a tachometer to the engine.
3. Bring the engine to normal operating temperature by driving the vehicle at highway speeds for approximately 15 minutes in (D) position.
4. After normal operating temperature is reached, maintain a constant vehicle speed of about 80 km/h (50 mph) and tap brake pedal with the left foot.
5. Engine rpm should increase when brake pedal is tapped, and decrease about five seconds after pedal is released. If this does not occur, see torque converter operation concerns. Refer to DIAGNOSIS BY SYMPTOM .
6. If the vehicle stalls in (D) or manual 2 at idle with vehicle at a stop, move the transmission range selector lever to manual 1 position. If the vehicle stalls, see torque converter operation concerns. Refer to DIAGNOSIS BY SYMPTOM . If the vehicle does not stall in (D), refer to DIAGNOSIS BY SYMPTOM .
7. If the vehicle exhibits a vibration during the road test, complete the Road Test Evaluation Form. This form will aid the technician in determining the source of the vibration.

• Spark plugs - check for cracks, high resistance or broken insulators
• Plug wires
• Fuel injector - filter may be plugged
• Fuel contamination - engine driveability concerns
• EGR valve - valve may let in too much exhaust gas and cause engine to run lean
• Vacuum leak - engine will not get correct air/fuel mixture
• MAP/MAF sensor - incorrect air/fuel mixture
• HO2S sensor - too rich/lean air/fuel mixture
• Fuel pressure - may be too low
• Engine mounts - loose/damaged mounts can cause vibration concerns
• Axle joints - check for vibration

Fig 1: Torque Converter Road Evaluation Specification (1 Of 2)

Courtesy of FORD MOTOR CO.

Fig 2: Torque Converter Road Evaluation Specification (2 Of 2)

Courtesy of FORD MOTOR CO.