Tie Rod End - Outer, E150 - E450: Installation

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the tie rod end (3A131).
- Turn the tie rod end into the tie rod adjusting sleeve clamp approximately the same number of turns used to remove old tie rod end. This will provide an approximate toe-in setting.
  
  Fig 1: Installing Tie Rod End (3A131)
  Courtesy of FORD MOTOR CO.
Tighten the tie rod adjusting sleeve clamp.

Fig 2: Tightening Tie Rod Adjusting Sleeve Clamp
Courtesy of FORD MOTOR CO.
Install the ball stud in the front wheel spindle, then tighten the castle nut.

Fig 3: Installing Ball Stud In Front Wheel Spindle And Tightening Castle Nut
Courtesy of FORD MOTOR CO.
Install a new cotter pin.
Check toe-in. Refer to SUSPENSION SYSTEM - GENERAL INFORMATION article. Ensure steering wheel is centered.