LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 314 (Driveshaft) >> Disassembly And Assembly >> Driveshaft Slip Yoke >> Disassembly

Driveshaft Slip Yoke: Disassembly

WARNING: This page is about a different car, the 2003 Ford RV Cutaway, 2003 Ford Econoline, 2003 Ford E550 Super Duty, 2003 Ford E450 Super Duty, and 2003 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not, under any circumstance, clamp the driveshaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture can result, causing driveshaft failure during vehicle operation.
  1. Place the driveshaft on a suitable workbench. Do not damage the tubes.
  2. Remove the driveshaft slip-yoke from the driveshaft.
    1. Cut and discard the driveshaft slip-yoke boot clamps.
    2. Remove the driveshaft slip-yoke from the driveshaft.
    Fig 1: Removing Driveshaft Slip-Yoke From Driveshaft
    G01440357Courtesy of FORD MOTOR CO.
  3. Remove the slip-yoke boot from the driveshaft.
    • Inspect the boot for damage. Discard the boot as necessary.
    Fig 2: Removing Slip-Yoke Boot From Driveshaft
    G01440358Courtesy of FORD MOTOR CO.
  4. Inspect the lubricant on the driveshaft splines and in the driveshaft slip-yoke for contamination. If contaminated, inspect the driveshaft splines and the driveshaft slip-yoke for wear. Install new components as necessary.
scientia non olet · About LEMON Manuals