LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Overhaul - Automatic Transmission) >> In-Vehicle Repair >> Intermediate Shaft Speed (ISS) Sensor >> Removal

Intermediate Shaft Speed (ISS) Sensor: Removal

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Disconnect Intermediate Shaft Speed (ISS) sensor electrical connector.
    Fig 1: Disconnecting ISS Sensor Electrical Connector
    G02152450Courtesy of FORD MOTOR CO.
  3. Remove ISS sensor.
    1. Remove the ISS sensor screw.
    2. Remove the ISS sensor from the transmission.
      • Inspect the ISS sensor O-ring for damage. If damaged, install a new O-ring.
    Fig 2: Removing ISS Sensor
    G02152451Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals