LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Overhaul - Automatic Transmission) >> Disassembly & Assembly Of Subassemblies >> Front Planetary & One-Way Clutch Assembly >> Assembly

Front Planetary & One-Way Clutch Assembly: Assembly

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: This step only needs to be carried out if the bearing was removed.
    Fig 1: Installing Front One-Way Clutch Into Special Tool
    G02152928Courtesy of FORD MOTOR CO.
  1. Install the front one-way clutch into the special tool with the brass end cap facing up.
    2. NOTE: This step only needs to be carried out if the bearing was removed.
    Fig 2: Inspecting That Front One-Way Clutch Is Flush With Special Tool
    G02152929Courtesy of FORD MOTOR CO.
  2. Inspect that the front one-way clutch is flush with the special tool.
    3. NOTE: This step only needs to be carried out if the bearing was removed.
    Fig 3: Assembling Special Tools With Front One-Way Clutch Onto Center Shaft
    G02152930Courtesy of FORD MOTOR CO.
  3. Assemble the special tools with the front one-way clutch onto the center shaft.
    4. NOTE: This step only needs to be carried out if the bearing was removed.
    Fig 4: Pushing Down On Center Shaft To Seat Front One-Way Clutch Into Center Shaft
    G02152931Courtesy of FORD MOTOR CO.
  4. Push down on the center shaft to seat the front one-way clutch into the center shaft.
    5. NOTE: This step only needs to be carried out if the bearing was removed.
    Fig 5: Inspecting Front One-Way Clutch For Correct Installation & Function
    G02152932Courtesy of FORD MOTOR CO.
  5. Inspect the front one-way clutch for correct installation and function. The front one-way clutch tabs should be flush with the center shaft.
  6. Install the center shaft and one-way clutch onto the overdrive ring gear.
    1. Install the center shaft and one-way clutch.
    2. Install the center shaft retaining ring.
    Fig 6: Installing Center Shaft & One-Way Clutch Onto Overdrive Ring Gear
    G02152933Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals