LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Automatic Transmission) >> In-Vehicle Repair >> Digital Transmission Range (TR) Sensor >> Removal

Digital Transmission Range (TR) Sensor: Removal

WARNING: This page is about a different car, the 2003 Mercury Marauder, 2003 Mercury Grand Marquis, and 2003 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Raise the vehicle on a hoist. For additional information, refer to JACKING & HOISTING .
  3. Disconnect the manual lever shift control cable.
    Fig 1: Disconnecting Manual Lever Shift Control Cable
    G01608349Courtesy of FORD MOTOR CO.
  4. Disconnect the digital TR sensor connector.
    Fig 2: Disconnecting Digital TR Sensor Connector
    G01608350Courtesy of FORD MOTOR CO.
  5. Remove the bolts and remove the digital TR sensor.
    Fig 3: Removing Bolts And Removing Digital TR Sensor
    G01608351Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals