BENCH MODE Procedure for EPC

WARNING: This page is about a different car, the 2003 Mercury Marauder, 2003 Mercury Grand Marquis, and 2003 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Follow operating instructions from the scan tool menu screen:

Select "Output State Control."
Select "Trans - Bench Mode."
Select "PIDs" to be monitored.
Monitor all selected PIDs during test.
Select "Parameters - EPC."
Select Value "0-620 kPa (0-90 psi)."
Press "SEND" to send command.
Select "XXX" to cancel at any time.
Press "SEND."