Manual Bleeding
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1999 Mercury Tracer, 1999 Mercury Mystique, 1999 Ford Escort, 1999 Ford Contour, and 1998 Mercury Tracer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Check fluid level in master cylinder frequently during brake bleeding sequence. Reservoir must be at least 3/4 full throughout bleeding sequence.
- Clean dirt from master cylinder fluid reservoir filler cap area. Fill reservoir with brake fluid. If master cylinder is known or suspected to have air in bore, bleed master cylinder first. To bleed brake system, release vacuum from power unit by depressing brake pedal several times.
- Install clear vinyl bleeder hose onto first bleed valve to be serviced. See BRAKELINE BLEEDING SEQUENCE table. Place other end of hose in clean transparent container.
- Partially fill container with clean brake fluid so end of hose is submerged in fluid. Open bleed valve 3/4 turn. Have an assistant slowly depress brake pedal through its full travel.
- Close bleed valve, and release pedal. Pump pedal several times to push air toward wheel cylinders. Repeat procedure until flow of brake fluid is clear and shows no sign of air bubbles. Proceed to next bleed valve.
- Check brake pedal for firmness. If brake pedal feels "spongy", repeat bleeding procedure. Top off brake fluid reservoir.
BRAKELINE BLEEDING SEQUENCE
| Application | Sequence |
|---|---|
| All Models | RR, LR, RF & LF |