LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2796 (Engine Controls - Pinpoint Test He: Exhaust Gas RECIRCULATION (EGR) Systems Through Pinpoint Test HZ: Natural Vacuum Leak Detection - (Except Diesel & Hybrid)) >> PINPOINT TEST HU: Intake Air Systems >> Introduction

PINPOINT TEST HU: Intake Air Systems: Introduction

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.

This pinpoint test is intended to diagnose the following:

Intake Manifold Runner Control Monitor (IMRCM) Sensor Connector 

For most vehicles the IMRCM is integrated into the IMRC connector.

Fig 2: Identifying Intake Manifold Runner Control Monitor (IMRCM) Sensor Connector
G07431352Courtesy of FORD MOTOR CO.
Fig 3: Identifying Intake Manifold Tuning Valve (IMTV) Actuator Connector
G07431355Courtesy of FORD MOTOR CO.

Powertrain Control Module (PCM) Connector 

For PCM connector views or reference values, refer to REFERENCE VALUES .

POWERTRAIN CONTROL MODULE (PCM) CONNECTOR PINS REFERENCE CHART

Vehicle Connector Pin Circuit
F-Series Super Duty 190-PIN E32
B69
E14
SIGRTN
PWRGND
IMTV
Focus 190-PIN E64
B69
E25
E22
SIGRTN
PWRGND
IMRCM
IMRC