DTC P0351: Ignition Coil A Primary/Secondary Circuit
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0351 - IGNITION COIL A PRIMARY/SECONDARY CIRCUIT
| Description: | Each ignition primary circuit is continuously monitored. The test fails when the powertrain control module (PCM) does not receive a valid ignition diagnostic monitor (IDM) pulse signal from the ignition module (integrated in the PCM). | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | DTC P035x only sets for a coil primary circuit failure. A secondary ignition coil or spark plug failure does not set DTC P035x. DTC P030x does not set for a coil primary circuit malfunction. DTC P035x may set with or without DTC P030x; however DTC P035x sets first. When this DTC is set, the PCM enters failure mode effects management (FMEM) which shuts down the injector for the associated cylinder in order to protect the catalytic converter. This is normal operation; do not attempt to diagnose the injector with this DTC present. If a primary coil is damaged due to a harness short to ground the PCM will not be damaged. Do not replace the PCM without verifying the coil driver functionality. Use the 12-volt non-powered test lamp to verify START/RUN voltage at the ignition coil harness connector. Check the coil driver circuit for open, short to voltage, or short to ground. |
||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Crown Victoria, E-Series, Edge, Escape / Mariner, Expedition, Explorer, F-150, F-Series Super Duty, Focus, Flex, Fusion, Grand Marquis, Milan, MKT, MKX, MKZ, Mustang, Navigator, Taurus, Town Car, Transit Connect |
GO to PINPOINT TEST JF . | ||
| Ranger, Fiesta |
GO to PINPOINT TEST JE . | ||