DTC P0192: Fuel Rail Pressure Sensor A Circuit Low
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2011 Mercury Milan, 2011 Mercury Mariner, 2011 Mercury Grand Marquis, 2011 Lincoln Town Car, and 2011 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
P0192 - FUEL RAIL PRESSURE SENSOR A CIRCUIT LOW
| Description: | The comprehensive component monitor (CCM) monitors the fuel rail pressure (FRP) sensor circuit to the powertrain control module (PCM) for low voltage. The test fails if the voltage falls below a calibrated limit for a calibrated amount of time during testing. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | A FRP PID value during ignition ON, engine OFF or ignition ON, engine running less than 0.3 volt indicates a concern is present. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DD . | ||