Removal and Installation

WARNING: This page is about a different car, the 2003 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: 2.3L is shown, 4.0L is similar.

Remove the air cleaner outlet pipe.
Loosen the clamp and disconnect the hose.
- Drain the fluid into a suitable container.
  
  Fig 1: Disconnecting Power Steering Hose
  Courtesy of FORD MOTOR CO.
Loosen the clamp and disconnect the hose.

Fig 2: Disconnecting Power Steering Hose
Courtesy of FORD MOTOR CO.
Remove the bolts and the reservoir.

Fig 3: Removing Reservoir
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Fill, purge and leak test the system. For additional information, refer to GENERAL INFORMATION .