LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2757 (Engine Controls - Pinpoint Test KE: Idle Air Control (IAC) Valve Through Pinpoint Test Z: Intermittent - (Except Diesel & Hybrid)) >> Pinpoint Test QE: Electronic Throttle Control (Etc) System >> Introduction

Pinpoint Test QE: Electronic Throttle Control (Etc) System: Introduction

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Milan, and 2006 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.

This pinpoint test is intended to diagnose the informational powertrain control module (PCM) DTCs.

The informational DTCs are the result of limited operating strategy (LOS) or failure mode effects management (FMEM) operating strategy that maintains limited vehicle function in the event of a PCM, harness, or component concern.

Circuit DTCs can be accompanied by the informational DTCs, and should be diagnosed first. Informational DTCs without circuit DTCs may or may not indicate the actual concern and should be diagnosed as a symptom.

Fig 1: EGR System Module (ESM) Connector
G04587275Courtesy of FORD MOTOR CO.