Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Lower the rear window.
Remove the rear door inner trim panel. Refer to INTERIOR TRIM & ORNAMENTATION -- FUSION, MILAN & MKZ article.
Remove the inner beltline weatherstrip.

Fig 1: Locating Inner Beltline Weatherstrip
Courtesy of FORD MOTOR CO.
Remove the screw and the outer beltline weatherstrip.

Fig 2: Locating Screw And Outer Beltline Weatherstrip
Courtesy of FORD MOTOR CO.
Position the rear window glass run aside.

Fig 3: Positioning Rear Window Glass Run
Courtesy of FORD MOTOR CO.
Remove the access hole plug.

Fig 4: Locating Access Hole Plug
Courtesy of FORD MOTOR CO.
Remove the rear quarter glass window guide bolt and screw.

Fig 5: Locating Rear Quarter Glass Window Guide Bolt And Screw
Courtesy of FORD MOTOR CO.
Remove the rear quarter glass window guide.

Fig 6: Identifying Rear Quarter Glass Window Guide
Courtesy of FORD MOTOR CO.
Remove the rear door fixed window glass.

Fig 7: Identifying Rear Door Fixed Window Glass
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.