LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 271 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Front Seat >> Removal & Installation (40 Percent Front Seat)

Removal & Installation (40 Percent Front Seat)

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Position front seat in forward position. Remove seat track rear anchor bolts. Move front seat to rearward position. Remove seat track front anchor bolts. Disconnect seat belt pretensioner electrical connector. Remove front seat.
  3. To install, reverse removal procedure. Tighten anchor bolts to specification. See TORQUE SPECIFICATIONS  . Connect negative battery cable. With air bag simulators installed at all remaining deployable devices, perform system operation check. See SYSTEM OPERATION CHECK  . Connect negative battery cable. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals