LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 269 (Air Bag Restraint Systems) >> Removal & Installation >> Front Seat >> Installation

Front Seat: Installation

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. DO NOT activate air bag system at this time. Install NEW front seat mounting bolts and tighten bolts to specification. See TORQUE SPECIFICATIONS  . Remove air bag simulator from side or side thorax air bag harness connector and reconnect connectors.
  2. Connect negative battery cable. With air bag simulators installed at all remaining deployable air bag system devices, perform system operation check. See SYSTEM OPERATION CHECK  . Disconnect negative battery cable. Wait at least one minute. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals