LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2680 (Manual Transaxle) >> In-Vehicle Repair >> Halfshaft Seal >> Installation

Halfshaft Seal: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Halfshaft Oil Seal Installer, install the RH intermediate shaft or the LH halfshaft oil seal.
    Fig 1: Installing RH Intermediate Shaft Using Halfshaft Oil Seal Installer
    G07786545Courtesy of FORD MOTOR CO.
    2. NOTE: Do not allow the splines on the halfshaft to touch the oil seal.
  2. Install the RH intermediate shaft or LH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.
  3. Fill the transaxle to specification. For additional information, refer to TRANSAXLE DRAINING AND FILLING  in this service information.
scientia non olet · About LEMON Manuals