LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 268 (Supplemental Restraint System - Air Bag Restraint Systems) >> Removal & Installation >> Front Seat >> Installation

Front Seat: Installation

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. DO NOT activate air bag system at this time. Tighten front seat mounting bolts to specification. See TORQUE SPECIFICATIONS  . Remove simulator from seat belt pretensioner harness connector and reconnect connectors.
  2. Connect negative battery cable. With air bag simulators installed at all remaining deployable air bag system devices, perform system operation check. See SYSTEM OPERATION CHECK  . Disconnect negative battery cable. Wait at least one minute. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals