LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2665 (Electronic Engine Controls - 2.5L (Except Hybrid)) >> Removal And Installation >> Knock Sensor (KS) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the intake manifold. For additional information, refer to ENGINE MECHANICAL - 2.5L -- FUSION & MILAN (EXCEPT HYBRID) article.
  3. Remove the bolt and the Knock Sensor (KS).
    • To install, tighten to 20 Nm (177 lb-in).
    4. NOTE: The KS must not touch the crankcase vent oil separator.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals