LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2641 (Power Steering System) >> Removal And Installation >> Steering Gear - 2.5L Hybrid and 3.0L All Wheel Drive (AWD) >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL(S)

G07780289
Ball Joint Separator
204-592
G07780290
Powertrain Lift
300-OTC1585AE or equivalent
Fig 1: Exploded View Of Steering Gear Components With Torque Specifications - 2.5L Hybrid And 3.0L AWD (1 Of 2)
G07780291Courtesy of FORD MOTOR CO.
ITEM DESCRIPTION

Item Part Number Description
1 W520416 Front subframe nuts (4 required)
2 3C496 Front subframe support bracket bolts (4 required)
3 5884 Subframe support bracket
4 W500545 Roll restrictor bolt
5 W506410 Electronic Power Assist Steering (EPAS) ground wire bolt
6 5C145 Front subframe
7 - EPAS jumper harness connector (2 required)
8 6E5C Tie-rod end nut (2 required)
Fig 2: Exploded View Of Steering Gear Components With Torque Specifications - 2.5L Hybrid And 3.0L AWD (2 Of 2)
G07780292Courtesy of FORD MOTOR CO.
ITEM DESCRIPTION

Item Part Number Description
9 W500550 Damper fork-to-front lower arm bolt (2 required)
10 3R827 Steering column shaft-to-steering gear bolt
11 3611B Steering gear/dash seal
12 W704904 Lower steering column shaft joint cover nut (2 required)
13 3611A Lower steering column shaft joint cover
14 3C494 Lower stabilizer bar link nut (2 required)
15 3053/3052 Stabilizer bar link (2 required)
16 - EPAS electrical connector (part of 3F720) (2 required)
17 3C497 Steering gear bolt (3 required)
18 3504 Steering gear