LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 264 (Rear Suspension) >> Removal And Installation >> Wheel Studs -Disc Brake >> Installation >> Vehicles with semi-floating axle

Vehicles with semi-floating axle

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Do not use the wheel nut that came with the vehicle.
    Fig 1: Installing Wheel Stud
    G00376996Courtesy of FORD MOTOR CO.
  1. Install washers and a wheel nut on the wheel stud and tighten the wheel nut until the wheel stud seats against the flange.
  2. Install the brake caliper and brake disc. For additional information, refer to DISC & DRUM .