LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2618 (Automatic Transaxle - AISIN Aw21) >> Diagnosis And Testing >> Transaxle Drive Cycle Test >> Before Pinpoint Tests

Before Pinpoint Tests

WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Prior to entering pinpoint tests, check the PCM wiring harness for correct connections, bent or broken pins, corrosion, loose wires, correct routing, correct seals and their condition. Check the PCM, sensors and actuators for damage. Refer to the INTRODUCTION - GASOLINE MODELS article or INTRODUCTION -- FUSION HYBRID, MILAN HYBRID & MKZ HYBRID article.
NOTE: If a concern still exists after electrical diagnosis has been carried out, refer to DIAGNOSIS BY SYMPTOM  in this service information. If DTCs appear while carrying out the on-board diagnostics, refer to the DIAGNOSTIC TROUBLE CODE (DTC) TABLES  in this service information for the appropriate repair
scientia non olet · About LEMON Manuals