LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2617 (Engine Mechanical - 2.5L (Hybrid)) >> In-Vehicle Repair >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Remove the through bolt from the Camshaft Front Oil Seal Installer.
    NOTE: Lubricate the oil seal with clean engine oil.
    Fig 1: Installing Crankshaft Front Oil Seal Using Camshaft Front Oil Seal Installer
    G07781925Courtesy of FORD MOTOR CO.
  1. Using the Camshaft Front Oil Seal Installer, install the crankshaft front oil seal.
  2. Install the crankshaft pulley. For additional information, refer to CRANKSHAFT PULLEY AND CRANKSHAFT FRONT SEAL - EXPLODED VIEW  and CRANKSHAFT PULLEY  in this service information.
scientia non olet · About LEMON Manuals