Cylinder Head - RH: Disassembly

WARNING: This page is about a different car, the 2011 Lincoln MKZ and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All cylinder heads

NOTE: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.

Using the Valve Spring Compressors, remove the keys, retainer and spring.

Fig 1: Remove/Install Keys, Retainer And Spring Using Valve Spring Compressors
Courtesy of FORD MOTOR CO.
Remove the valve from the cylinder head.
Remove and discard the valve stem seal.
Repeat the above steps for each valve.
Remove the timing chain guide pin.
RH cylinder head
Remove the timing chain tensioner arm pin.
Remove and discard the Cylinder Head Temperature (CHT) sensor.