In-Vehicle Repair: Flexplate: Installation

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Special bolts are used for installation. Do not use standard bolts.

Fig 1: Identifying Flexplate Bolts Tightening Sequence

Courtesy of FORD MOTOR CO.

Install the flexplate and tighten the bolts in the sequence shown in the illustration in 3 stages.
- Stage 1: Tighten to 50 Nm (37 lb-ft).
- Stage 2: Tighten to 80 Nm (59 lb-ft).
- Stage 3: Tighten to 112 Nm (83 lb-ft).
Install the automatic transaxle. For additional information, refer to the appropriate automatic transmission service information.
After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.