LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2614 (Engine Mechanical - 2.5L (Except Hybrid)) >> In-Vehicle Repair >> Exhaust Manifold >> Removal

Exhaust Manifold: Removal

WARNING: This page is about a different car, the 2011 Mercury Milan and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  2. Remove the exhaust flexible pipe. For additional information, refer to EXHAUST SYSTEM -- FUSION, MILAN & MKZ article.
  3. Disconnect the Heated Oxygen Sensor (HO2S) electrical connector.
  4. Remove the 4 exhaust manifold heat shield bolts and the heat shield.
  5. If equipped, detach the block heater wire harness retainer from the exhaust manifold stud.
  6. Remove and discard the 7 exhaust manifold nuts.
  7. Remove the exhaust manifold and discard the exhaust manifold gasket.
  8. Remove and discard the 7 cylinder head studs.
  9. Clean and inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
scientia non olet · About LEMON Manuals