LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2610 (Engine Controls - Diagnostic Methods (Except Diesel & Hybrid)) >> Output Test Mode (OTM) >> Description >> Failure To Follow These Instructions May Result In Personal Injury

Failure To Follow These Instructions May Result In Personal Injury

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2011 Mercury Mariner, 2011 Lincoln Navigator L, 2011 Lincoln Navigator, 2011 Lincoln MKX, and 2011 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

The OTM aids in diagnosing output actuators associated with the powertrain control module (PCM). This mode allows the technician to energize and de-energize most of the system output actuators on command. When entering OTM, the outputs can be turned off and on without activating the fan control. The low and high speed fan controls may be turned on separately without energizing the other outputs. This function is supported by each vehicle strategy and may not be available on all scan tools.

As a safety precaution, OTM defaults to the off state after 10 minutes, and the fuel pump off state after approximately 7-10 seconds. OTM also turns off after the vehicle is started or after cycling the key OFF, then ON.