LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Rear Suspension System) >> Removal & Installation >> Wheel Knuckle - 2WD >> Installation >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2004 Ford Escape, 2003 Ford Escape, and 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tools, install a new wheel bearing into the wheel knuckle.
    Fig 1: Installing Wheel Bearing (2WD)
    G00370555Courtesy of FORD MOTOR CO.
  2. Install the snap ring into the wheel knuckle.
  3. Position the brake backing plate to the wheel knuckle and install the bolts.
  4. Using the wheel hub washer and the special tool, install the wheel hub into the wheel bearing.
    Fig 2: Installing Wheel Hub (2WD)
    G00370556Courtesy of FORD MOTOR CO.
    5. NOTE: If equipped, install the ABS sensor ring.
  5. Install the wheel hub nut.
  6. Position the wheel knuckle and install the wheel knuckle cam.
  7. Install the wheel knuckle cam bolt and nut loosely.
  8. Support the wheel knuckle and install the spring.
  9. Install the lower shock absorber nut.
  10. Position the upper ball joint and install the nut.
  11. Position the lower ball joint and install the nut.
  12. Align the wheel knuckle cam. Tighten the wheel knuckle cam bolt and nut.
  13. Connect the brake line to the wheel cylinder. Install the brake line bracket bolt.
  14. Install the parking brake cable through the brake backing plate. Install the bolt. Install the parking brake cable.


  1. Install the brake shoes. See DISC & DRUM .
  2. Bleed the brake system. See DISC & DRUM .
  3. Check and adjust the wheel alignment as necessary. See SPECIFICATION & PROCEDURES .
scientia non olet · About LEMON Manuals