LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2575 (Wiper System & Washer System) >> Removal And Installation >> Washer Pump and Reservoir >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bolt and position the windshield washer reservoir aside.
  2. Disconnect the windshield washer pump electrical connector.
  3. Disconnect the windshield washer fluid level sensor electrical connector.
    4. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
    NOTE: Windshield washer fluid should be collected in a container after the windshield washer hose is disconnected.
  4. Remove the windshield washer reservoir.
    • Disconnect the windshield washer hose.
  5. Remove the windshield washer pump.
    6. CAUTION: Do not operate the windshield washer pump prior to filling the windshield reservoir. Failure to follow this instruction may result in premature pump failure.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals