LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2550 (Engine Mechanical - 4.6L (2V)) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold - LH .
  3. Remove the oil level indicator.
  4. Remove the bolt and the oil level indicator tube.
    • To install, tighten to 10 Nm (89 lb-in).
    5. NOTE: Failure to lubricate the O-ring seal and the oil level indicator tube-to-engine block mating surface with clean engine oil can result in engine oil leaks.
    NOTE: Make sure the O-ring seal remains in position and does not roll up the indicator tube during installation.
  5. Remove the O-ring seal and discard.
  6. To install, reverse the removal procedure.
    • Lubricate the new O-ring seal and engine mating surface with clean engine oil.
scientia non olet · About LEMON Manuals