Normal Operation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
The right rear heated seat module receives voltage feed on circuit 1445 (RD/LG), ignition voltage feed on circuit 1040 (RD/BK) and is supplied ground on circuit 57 (BK). When the heated seat control switch is pressed with the ignition switch in RUN or START, a ground signal is sent to the heated seat module on circuit 1256 (WH/YE) to command the system ON or OFF (LOW heat mode).
This pinpoint test is intended to diagnose the following:
- Wiring, terminals or connectors
- Heated seat switch
- Heated seat module