LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2533 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Removal And Installation >> Instrument Cluster (IC) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If installing a new Instrument Cluster (IC), it is necessary to upload the IC configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION article.
  1. Remove the IC finish panel. For additional information, refer to INSTRUMENT PANEL & CONSOLE article.
  2. Depower the Supplemental Restraint System (SRS). For additional information, refer to GENERAL PROCEDURES article.
    3. NOTE: Release the upper steering column shroud by pressing the sides inward.
  3. Remove the upper steering column shroud.
  4. Remove the screw and the transmission range indicator from the steering column.
    • Disconnect the transmission range indicator cable from the shift selector arm.
  5. Remove the 4 screws and the IC.
    • Disconnect the electrical connector.
  6. To install, reverse the removal procedure.
    • If a new IC was installed, download the IC configuration information from the scan tool into the new IC. For additional information, refer to MODULE CONFIGURATION article.
scientia non olet · About LEMON Manuals