Muffler & Tailpipe: Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Check the isolator for wear or damage. Install a new isolator as necessary.

Install the tailpipe and attach the isolator.

NOTE: Check the isolator for wear or damage. Install a new isolator as necessary.

Install the muffler and attach the isolator.

NOTE: Install new exhaust fasteners. Do not tighten the fasteners until all components are assembled.

NOTE: Alternately tighten the fasteners to specification, to draw flanges together evenly.

Connect the muffler and tailpipe and install new fasteners.
- Tighten to 33 Nm (24 lb-ft).

Fig 1: Muffler-To-Tailpipe Flange

Courtesy of FORD MOTOR CO.

Connect the exhaust inlet pipe and muffler.
- Install the exhaust inlet pipe-to-muffler clamp, the exhaust damper (if equipped) and the 2 nuts.
  - Tighten to 48 Nm (35 lb-ft).

Fig 2: Identifying Exhaust Inlet Pipe-To-Muffler Clamp With Specifications

Courtesy of FORD MOTOR CO.