Installation (All Models)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2001 Ford Pickup, 2001 Ford Expedition, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure. Apply silicone sealant on front cover and seal retainer-to-cylinder block areas before installing gasket and oil pan. Tighten all bolts to specification in sequence. See Fig 1. See TORQUE SPECIFICATIONS .
When installing fuel lines, fit NEW fuel resistant "O" rings (Brown) on fuel lines. Lightly coat "O" rings with clean engine oil before installing. Clean fittings, and replace garter spring (if necessary).
Adjust all control cables and fluid levels. Refill cooling system. Evacuate and recharge A/C system.

Fig 1: Oil Pan Bolt Tightening Sequence (All Models)

Courtesy of FORD MOTOR CO.