LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Engine - 4.6L V8 - VIN W & 6) >> Overhaul >> Cylinder Block Assembly >> Fitting Pistons

Fitting Pistons

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2001 Ford Pickup, 2001 Ford Expedition, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
  1. Standard service pistons are color-coded Red, Blue or Yellow on dome of piston. Measure piston skirt diameter at 90-degree angle to piston pin, 1.62" (42.0 mm) below piston top. Replace piston if piston diameter is not within specification. See PISTONS, PINS & RINGS  table under ENGINE SPECIFICATIONS.
  2. Measure cylinder bore at 1/2" below top of piston travel and 1/2" above bottom of piston travel. Ensure piston clearance is within specification. See PISTONS, PINS & RINGS  table.
  3. If piston clearance is not within specification, choose a selective fit piston to bring piston clearance within specification. See PISTONS, PINS & RINGS  table, for selective fit piston sizes.
  4. If piston clearance cannot be corrected using a selective fit piston, bore all cylinders to nearest oversize.
scientia non olet · About LEMON Manuals